Jump to content
  • Welcome to Celiac.com!

    You have found your celiac tribe! Join us and ask questions in our forum, share your story, and connect with others.




  • Celiac.com Sponsor (A1):



    Celiac.com Sponsor (A1-M):


  • Get Celiac.com Updates:
    Support Our Content
    eNewsletter
    Donate

Not Rising Enough & Which Beater To Use?


WVSweetie Pie

Recommended Posts

WVSweetie Pie Rookie

Last week I baked the flax bread that everyone has raved about. It was quite good, but I did not experience what I think should have been sufficient rising. Most people mention even going over the top of the pan. Mine did raise (somewhat unevenly) to the top of the pan, but during backing and cooling did shrink some. The middle of the bread was probably only 2 or 2 1/2 in. high. The sides were somewhat higher.

My ingredients were room temp. and my yeast was new. I wonder about the beating. I used the flat beater from my Kitchen Aid mixer. Should I have used the other one to incorporate more air into the batter?

Thanks for your experienced help.


Celiac.com Sponsor (A8):
Celiac.com Sponsor (A8):



Celiac.com Sponsor (A8-M):



TiffersAnn Apprentice

Sometimes the humidity outside can even effect rising. If it's raining or really sticky hot outside I don't even bother baking. As for your beater type, more air in the batter would help.

sa1937 Community Regular

Baking gluten free yeast bread is my biggest challenge. It seems they usually only rise to the top of the pan but I never get what I'd call "oven spring". So I'm still trying to find that deep dark secret myself.

I use the flat paddle attachment on my KitchenAid mixer.

I think there are probably several of us trying to figure out the magic of baking. The breads I've baked are generally edible although I have thrown out a few bricks. ph34r.gif

WVSweetie Pie Rookie

Sometimes the humidity outside can even effect rising. If it's raining or really sticky hot outside I don't even bother baking. As for your beater type, more air in the batter would help.

Thanks for your thoughts. Next time, I'll check the weather!

WVSweetie Pie Rookie

Baking gluten free yeast bread is my biggest challenge. It seems they usually only rise to the top of the pan but I never get what I'd call "oven spring". So I'm still trying to find that deep dark secret myself.

I use the flat paddle attachment on my KitchenAid mixer.

I think there are probably several of us trying to figure out the magic of baking. The breads I've baked are generally edible although I have thrown out a few bricks. ph34r.gif

I used the flat paddle last week when I tried my first loaf. The dough rose to the top, but lost height while baking and cooling. (It didn't fall)

Today, I used the dough hook. What the heck is it for anyway? Made sense to me. Anyway, again the dough rose to the top and after about 45 min. rising, began to lose height. It continued to go down as it baked and consequently, my slices are only 2 inches high. It's smaller than the one I made last week. It's delicious, but what's wrong? Shouldn't it be taller than that? After all that work, all those ingredients, and cleaning up half the dishes in my kitchen, shouldn't there be a greater reward?

sa1937 Community Regular

I used the flat paddle last week when I tried my first loaf. The dough rose to the top, but lost height while baking and cooling. (It didn't fall)

Today, I used the dough hook. What the heck is it for anyway? Made sense to me. Anyway, again the dough rose to the top and after about 45 min. rising, began to lose height. It continued to go down as it baked and consequently, my slices are only 2 inches high. It's smaller than the one I made last week. It's delicious, but what's wrong? Shouldn't it be taller than that? After all that work, all those ingredients, and cleaning up half the dishes in my kitchen, shouldn't there be a greater reward?

I think most cookbooks call for using the flat paddle as gluten free "doughs" are really more like batters than doughs. Contrast that to wheat flour with lots of elasticity, which uses the dough hook. We try to achieve that with xanthan gum and possibly other ingredients, too.

Hmmm...yes it should have been taller. And what's wrong? Good question and one I've always struggled with, too, and continue to stuggle with. And yes, I understand using a lengthy list of ingredients, having my kitchen a disaster area and very little reward. I only wish I had the answer.

mushroom Proficient

I think most cookbooks call for using the flat paddle as gluten free "doughs" are really more like batters than doughs. Contrast that to wheat flour with lots of elasticity, which uses the dough hook. We try to achieve that with xanthan gum and possibly other ingredients, too.

Hmmm...yes it should have been taller. And what's wrong? Good question and one I've always struggled with, too, and continue to stuggle with. And yes, I understand using a lengthy list of ingredients, having my kitchen a disaster area and very little reward. I only wish I had the answer.

I, too, have yet to get an "oven" rise out of my dough; the bread always ends up smaller than when baking started. I think I am going to try halfrunner's trick of adding some baking powder to it :P


Celiac.com Sponsor (A8):
Celiac.com Sponsor (A8):



Celiac.com Sponsor (A8-M):



sa1937 Community Regular

I, too, have yet to get an "oven" rise out of my dough; the bread always ends up smaller than when baking started. I think I am going to try halfrunner's trick of adding some baking powder to it tongue.gif

I've thought of doing that with every bread I make but haven't tried it yet unless a recipe specifically calls for it. BTW, her buckwheat bread is really tasty. Yum!

mushroom Proficient

I've thought of doing that with every bread I make but haven't tried it yet unless a recipe specifically calls for it. BTW, her buckwheat bread is really tasty. Yum!

I haven't tried the revised version yet :rolleyes:

RiceGuy Collaborator

I used the flat paddle last week when I tried my first loaf. The dough rose to the top, but lost height while baking and cooling. (It didn't fall)

Today, I used the dough hook. What the heck is it for anyway? Made sense to me. Anyway, again the dough rose to the top and after about 45 min. rising, began to lose height. It continued to go down as it baked and consequently, my slices are only 2 inches high. It's smaller than the one I made last week. It's delicious, but what's wrong? Shouldn't it be taller than that? After all that work, all those ingredients, and cleaning up half the dishes in my kitchen, shouldn't there be a greater reward?

I've found that over-rising will lead to exactly what you describe. It can't continue rising as much as wheat dough. If it goes too high, the binders simply cannot hold the bubbles any more, and they begin to collapse. Keep in mind that some of the rise should occur during baking. I find that the softer the dough, the more of the total rise should occur during baking. Thus it shouldn't be allowed to get too tall before then. Another factor can be insufficient water, but it sounds like the recipe you're using is tried and true.

I recently discovered that my measuring cup is inaccurate. It would not surprise me if others also have trouble because the measurements aren't the same as those of the recipe's originator.

WVSweetie Pie Rookie

I've found that over-rising will lead to exactly what you describe. It can't continue rising as much as wheat dough. If it goes too high, the binders simply cannot hold the bubbles any more, and they begin to collapse. Keep in mind that some of the rise should occur during baking. I find that the softer the dough, the more of the total rise should occur during baking. Thus it shouldn't be allowed to get too tall before then. Another factor can be insufficient water, but it sounds like the recipe you're using is tried and true.

I recently discovered that my measuring cup is inaccurate. It would not surprise me if others also have trouble because the measurements aren't the same as those of the recipe's originator.

Thanks, Rice Guy, I never dreamed that perhaps the bread was over-rising. I'll keep that in mind next time. Yes, that recipe has been used by many with great success, but I am new to breadmaking using all the various ingredients. Before this, I had always used the Bob Mills gluten-free multigrain bread mix, but found myself reacting recently to it for some reason. I had successfully used it for over 2 years and loved it.

I also wondered about beating the dough. I will use my flat paddle again as I did the first time. The recipe calls for beating the dough for 3-4 minutes on medium. One person even mentioned beating hers on high for 5 minutes. How would beating it for too little or too much affect the dough? Could it have a bearing on my results?

I will check my measuring cups also.

RiceGuy Collaborator

The recipe calls for beating the dough for 3-4 minutes on medium. One person even mentioned beating hers on high for 5 minutes. How would beating it for too little or too much affect the dough? Could it have a bearing on my results?

Beating for too short a time may lead to uneven distribution of the ingredients. But I am not aware of any real problems from beating a little longer or a little faster. The suggested 3-4 minutes should be sufficient. Too long can allow the dough to cool more, and thus may require a little extra rise time. It may also allow the dough to lose additional moisture due to evaporation. The room's temperature and humidity will have some bearing on these factors.

I have also found that covering the pan while the dough rises is very important. Otherwise the surface of the dough tends to dry out, crack, and thus allows the gas from the yeast, and the steam created during baking, to escape. Thereby leading to a much-reduced height.

WVSweetie Pie Rookie

Thanks, again, RiceGuy for your thoughts and experience. I'll keep these things in mind when I try this recipe again. It really is good.

Archived

This topic is now archived and is closed to further replies.

  • Get Celiac.com Updates:
    Support Celiac.com:
    Join eNewsletter
    Donate

  • Celiac.com Sponsor (A17):
    Celiac.com Sponsor (A17):





    Celiac.com Sponsors (A17-M):




  • Recent Activity

    1. - Scott Adams replied to HAUS's topic in Gluten-Free Foods, Products, Shopping & Medications
      7

      Sainsbury's Free From White Sliced Bread - Now Egg Free - Completely Ruined It

    2. - Scott Adams replied to deanna1ynne's topic in Celiac Disease Pre-Diagnosis, Testing & Symptoms
      13

      Inconclusive results

    3. - deanna1ynne replied to deanna1ynne's topic in Celiac Disease Pre-Diagnosis, Testing & Symptoms
      13

      Inconclusive results

    4. - cristiana replied to HAUS's topic in Gluten-Free Foods, Products, Shopping & Medications
      7

      Sainsbury's Free From White Sliced Bread - Now Egg Free - Completely Ruined It


  • Celiac.com Sponsor (A19):



  • Member Statistics

    • Total Members
      132,437
    • Most Online (within 30 mins)
      7,748

    rednecksurfer
    Newest Member
    rednecksurfer
    Joined

  • Celiac.com Sponsor (A20):


  • Forum Statistics

    • Total Topics
      121.5k
    • Total Posts
      1m

  • Celiac.com Sponsor (A22):





  • Celiac.com Sponsor (A21):



  • Upcoming Events

  • Posts

    • Scott Adams
      In the U.S., most regular wheat breads are required to be enriched with certain B-vitamins and iron, but gluten-free breads are not required to be. Since many gluten-free products are not enriched, we usually encourage people with celiac disease to consider a multivitamin.  In the early 1900s, refined white flour replaced whole grains, and people began developing serious vitamin-deficiency diseases: Beriberi → caused by a lack of thiamin (vitamin B1) Pellagra → caused by a lack of niacin (vitamin B3) Anemia → linked to low iron and lack of folate By the 1930s–40s, these problems were common in the U.S., especially in poorer regions. Public-health officials responded by requiring wheat flour and the breads made from it to be “enriched” with thiamin, riboflavin, niacin, and iron. Folic acid was added later (1998) to prevent neural-tube birth defects. Why gluten-free bread isn’t required to be enriched? The U.S. enrichment standards were written specifically for wheat flour. Gluten-free breads use rice, tapioca, corn, sorghum, etc.—so they fall outside that rule—but they probably should be for the same reason wheat products are.
    • Scott Adams
      Keep in mind that there are drawbacks to a formal diagnosis, for example more expensive life and private health insurance, as well as possibly needing to disclose it on job applications. Normally I am in favor of the formal diagnosis process, but if you've already figured out that you can't tolerate gluten and will likely stay gluten-free anyway, I wanted to at least mention the possible negative sides of having a formal diagnosis. While I understand wanting a formal diagnosis, it sounds like she will likely remain gluten-free either way, even if she should test negative for celiac disease (Approximately 10x more people have non-celiac gluten sensitivity than have celiac disease, but there isn’t yet a test for NCGS. If her symptoms go away on a gluten-free diet, it would likely signal NCGS).        
    • JoJo0611
    • deanna1ynne
      Thank you all so much for your advice and thoughts. We ended up having another scope and more bloodwork last week. All serological markers continue to increase, and the doc who did the scope said there villous atrophy visible on the scope — but we just got the biopsy pathology report back, and all it says is, “Duodenal mucosa with patchy increased intraepithelial lymphocytes, preserved villous architecture, and patchy foveolar metaplasia,” which we are told is still inconclusive…  We will have her go gluten free again anyway, but how soon would you all test again, if at all? How valuable is an official dx in a situation like this?
    • cristiana
      Thanks for this Russ, and good to see that it is fortified. I spend too much time looking for M&S gluten-free Iced Spiced Buns to have ever noticed this! That's interesting, Scott.  Have manufacturers ever said why that should be the case?  
×
×
  • Create New...

Important Information

NOTICE: This site places This site places cookies on your device (Cookie settings). on your device. Continued use is acceptance of our Terms of Use, and Privacy Policy.